P-409-B Filler for bad reproducer back

P-409-B Filler for bad reproducer back.  When the liner at the reproducer back is worn out, this rubber filler can possibly replace it.  Shown in the photo are the steps in making it fit.  The liner is black rubber tubing, approximately 7/8″ outer diameter with 1/16″ thick wall.  It is cut to 1/2″ length, enough to fit the reproducer attachment hole. (It will work best if the hole at the back of the reproducer is 3/4″ diameter and the tone arm end where the reproducer is to be attached is 5/8″ diameter.  This filler may not work with other parts dimensions.)  The steps, shown in the photo below, should be followed to make this filler replace the bad liner.  Print a copy of the steps shown below.

NOTE: Since the minimum shipping charge is $5 in the USA, the cost of the filler is only 25 cents, so the total cost for shipping one liner (in the USA) is only $5.25.  You may order up to 59 fillers at the same time while the shipping cost will still be only $5.  (59 x $0.25 = 14.75. Add $5 for s/h.  Total = $19.75 for 59 liners – shipped in the USA)  But who needs 59 liners?   🙂